Click here to download the catalog as a PDF file.


Pioneer user manual - Page 1

Setting Up your XV-DV303 DVD/CD Receiver When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet. Do not use these speakers with any other system or amplifier as this may result in damage or fire. 1 Check that you have all the accessories, then put the batteries in the remote control. Batteries and remote control Power cord * * In some countries or regions, the shape of the power plug may sometimes differ from that shown in the explanatory drawings. 2 Connect the AM and FM antennas to the rear panel of the DVD receiver. Using the remote control The remote control can be used within a range of about 7 meters from the remote sensor on the front panel, and within a 30 degree angle. Precautions: 1 Pull off the protective shields of both AM antenna wires. fig. a fig. b fig. c 2 Push open the tabs, then insert one wire fully into each terminal. Video cord 4 6 ANTENNA UNBAL 75Ω FM AM LOOP ANTENNA • The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote control is not directed towards the remote sensor of the display unit at the correct angle. • The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the unit’s remote sensor. • The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote controls of other devices which use infrared rays are used. Also, the use of this remote control may cause other devices to work improperly. • When the operating range of the remote becomes too short, replace the batteries. Remote control battery caution Incorrect use of batteries may cause leakage or rupture. Always be sure to follow these guidelines: • Always insert batteries into the battery compartment correctly matching the positive ª and negative · polarities, as shown by the display inside the compartment. • Never mix new and used batteries. • Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. • In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. • Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. 3 Release the tabs to secure the AM antenna wires. European model 1 2 3 4 FM antenna AM loop antenna Satellite speakers: • • • • • Center (1) Front/Surround (x4) Subwoofer (1) Speaker cords (x6) Non-slip pads (x24) Fix the AM loop antenna to the attached stand. To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. A) then clip the loop onto the stand (fig. B). Note: If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. C) before clipping the loop to the stand. Make sure the reception is clear. ANTENNA FM UNBAL 75Ω AM LOOP ANTENNA Australia and New Zealand models Additional notes on connecting antennas • Keep antenna cables away from other cables and the display unit and main set. • To assure optimum reception, pull the FM antenna so that it is fully extended and not coiled or hanging at the rear of the unit. • If reception with the supplied antenna is poor, see the Additional Connections section in the main operating instructions for details on connecting outdoor antennas. 5 Place the AM antenna on a flat surface and point in the direction giving the best reception. Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances. 6 Connect the FM wire antenna to the FM UNBAL 75Ω antenna terminal. For best results, extend the FM antenna fully and fix to a wall or door frame. Don’t drape loosely or leave coiled up. Note: The signal earth (H) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth. Additional notes on speaker placement Place speakers as shown in step 4 to achieve the optimum surround sound effect • Install the main front left and right speakers at an equal distance from the TV. • For optimum effect, install the rear speakers slightly above ear level. • This system's speakers are magnetically shielded, so there's virtually no picture color distortion when they are placed near a TV. In the rare event that there is some picture color interference, switch power to the TV off, and wait 15 to 30 minutes before switching on again. • Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. • When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. • Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire. 1 2 3 3 Connect each speaker using the color-coded speaker cords. Match them to the colored labels above the speaker terminals. Surround right (Grey) Surround left (Blue) Connect each speaker as shown below. 4 Color coding Connect the DVD/CD receiver to your TV, then connect the supplied power cord. 1 Connect one end to a video input on your TV. Connect the other end to the video output of the DVD receiver. This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. 1 Twist and pull off the FRONT R L SUB WOOFER SURROUND CENTER R L 2 IN IN OUT OPTICAL IN AUDIO LINE 2 protective shields on each wire. FM ANTENNA UNBAL 75Ω AM LOOP ANTENNA L R TV AUDIO LINE 1 3 Listening position Connect the power cord to the AC inlet. SPEAKERS 6 6 6 6 6 6 AC IN S-VIDEO VIDEO OUT OUT VIDEO 2 Connect one end to the DVD Subwoofer (Purple) receiver. Match the colored wire with the color-coded label (above the tabs), then insert the colored wire into the red (+) tab and the other wire with the black (–) tab. FRONT R L SUB WOOFER SURROUND CENTER R L VIDEO IN IN IN OUT OPTICAL IN AUDIO LINE 2 L R TV AUDIO LINE 1 FM ANTENNA UNBAL 75Ω AM LOOP ANTENNA SPEAKERS 6 6 6 6 6 6 AC IN S-VIDEO VIDEO OUT OUT VIDEO Front right (Red) Center (Green) Front left (White) 3 Connect the other end to the speaker in the same way. AC IN S-VIDEO VIDEO OUT OUT VIDEO For the best surround sound, setup your speakers as above. The front left and right speakers should be about 1.8–2.7 m apart. To AC outlet Remove the supplied non-slip pads from the paper, and stick four onto the base of each satellite speaker. Actual speakers supplied may differ from those shown. These speaker terminals can be under HAZARDOUS VOLTAGE. When you connect or disconnect the speaker cables, to prevent the risk of electric shock, do not touch uninsulated parts before disconnecting the power cord. Congratulations! You're done setting up. Published by Pioneer Corporation. Copyright © 2002 Pioneer Corporation. All rights reserved. Printed in

Page 2