Pioneer user manual - Page 1

Installation Installation CD RDS RECEIVER REPRODUCTOR DE CD CON RECEPTOR RDS CD RDS-EMPFÄNGER AUTORADIO CD RDS SINTOLETTORE CD RDS CD RDS-ONTVANGER CD RDS ПРИЕМНИК Important ! Check all connections and systems before final installation. ! Do not use unauthorized parts. Use of unauthorized parts may cause malfunctions. ! Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. ! Do not install this unit where : — it may interfere with operation of the vehicle. — it may cause injury to a passenger as a result of a sudden stop. ! The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet. ! Optimum performance is obtained when the unit is installed at an angle of less than 60°. 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 3 Install the unit. Rubber bush DIN Rear-mount 1 Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.) Fastening the front panel If you do not plan to detach the front panel, the front panel can be fastened with supplied screw. Dashboard DEH-1120MP DEH-1100MPB DEH-1100MP DEH-112E DEH-110E Screw Trim ring Mounting sleeve Screw ! It becomes easy to remove the trim ring if the front panel is released. Removing the unit 1 Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.) 2 Determine the appropriate position where the holes on the bracket and the side of the unit match. 60° 3 Tighten two screws on each side. DIN front/rear mount This unit can be properly installed either from “Front” (conventional DIN front-mount) or “Rear” (DIN rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following installation methods. Trim ring Screw Installation Manual Manual de instalación Installationsanleitung Manuel d’installation Manuale d’installazione Installatiehandleiding Руководство по установке <08H00000> ! It becomes easy to remove the trim ring if the front panel is released. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. 3 Pull the unit out of the dashboard. Mounting bracket Dashboard or console DIN Front-mount Installation with the rubber bush 1 Insert the mounting sleeve into the dashboard. When installing in a shallow space, use a supplied mounting sleeve. If there is enough space behind the unit, use factory supplied mounting sleeve. En ! Use either truss screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), depending on the shape of screw holes in the bracket. Printed in Thailand Imprimé en Thaïlande  EW En

Page 2